The most obvious sign that your vacuum needs a new belt is when the brush bar stops turning properly..

Start by checking your carpet fibres.. We only recommend using a rake on cut-pile or shag carpets.. Give your carpet a thorough vacuum.If possible, use a vacuum with a rotating brush bar to pull up more hair and dirt.. Gently use the rake on your carpet by pulling in one direction, but be careful not to press too hard to push the rake too deep into the fibres.

The rake should glide smoothly – if it’s not, then you’re pressing too hard.. Now use the rake in both directions, moving forward and backwards.This step helps to fluff up the carpet fibres.. Give your carpet another thorough vacuum to remove any dirt, hair, and dust that’s been agitated during raking..Finish by raking in a single direction (pulling towards you) to give your carpet that “new” appearance..

: Don’t use a carpet rake on a woven or Berber carpet.The rake may pull out or damage the fibres..

Method 3: Clean Dirty Patches of Carpet With White Vinegar.

White vinegar is a. useful tool for cleaning carpets.The first is a thinner felt filter, followed by a thicker foam filter.

Make sure you remember which way these go, as it’s important to put them back in the same order..Step 3: Rinse The Filters In Fresh Water.

You can now rinse the filters under a cold water tap to remove any clogging or debris that’s stuck to the surface.Keep washing the filter until the water runs clear.. Only use cold water to clean the Shark CH950UKT’s filters.